Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide

5–32 Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide
Initiator Site Clean-Up
1. Re-enable logging or failsafe, if desired. To set failsafe issue the following CLI
command:
SET RemoteCopySetName ERRORMODE=FAILSAFE
NOTE: Failsafe cannot be set if the remote copy set is within an association set that is to be
used for write history logging.
To re-enable logging, create the log unit, then create the association set and assign the
log unit to the association set.
NOTE: Refer to the Configuration chapter for information on how to create association sets and
configure association sets for write history logging
2. If the initiator hosts were shut down, reboot them at this time. Rename all
!NEWCONxx connections to their previous names. For OpenVMS, change the
operating system to OpenVMS for each new connection with the following command:
SET !NEWCONXX OPERATING_SYSTEM = VMS
3. Enable host access to the units by using the following CLI command:
SETUnitName ENABLE=(InitiatorHostConnectionNamex,InitiatorHostConnectionNamey)
4. To verify that all of these steps have been completed successfully, issue this CLI
command:
SHOW REMOTE_COPY FULL
The output shows you a list of remote copy sets. Be sure that the units you see are the
ones from the target site and not the initiator units.
5. Set maximum cached transfer size to the original value using the following CLI
command:
SET UnitName MAXIMUM_CACHE_TRANSFER_SIZE = initiator value
6. To verify that the initiator host can connect to the LUNs, use this command:
SHOW UNITS FULL
In the Access field of the display, all units should show that the initiator hosts are
enabled.
7. For Windows NT, reboot the host at the initiator site, and log in as Administrator. You
should be able to see all of the drives in My Computer.