Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide

5–30 Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide
Creating Connections from the Initiator Site to the Target
1. Issue the following CLI command:
ADD REMOTE_COPY_SETS RCS199 D199 TargetRemoteCopyName\D199
NOTE: This command will fail, but creates and names the connections appropriately.
2. Set access for all of the units to TargetRemoteCopyNameA,
TargetRemoteCopyNameB,TargetRemoteCopyNameC, TargetRemoteCopyNameD:
SET UnitName ENABLE = (TargetRemoteCopyNameA,TargetRemoteCopyNameB,
TargetRemoteCopyNameC,TargetRemoteCopyNameD)
Repeat this procedure for all units.
Copying Data From the Target Site to the Initiator
1. Set initiator access to all remote copy units.
SET UnitName ENABLE = (InitiatorRemoteCopyNameA,InitiatorRemoteCopyNameB,
InitiatorRemoteCopyNameC,InitiatorRemoteCopyNameD)
Repeat this step for all units
2. Add back the initiator unit to the remote copy sets with the following CLI command:
SET RemoteCopySetName ADD = InitiatorRemoteCopyName\UnitName
Repeat this step for all remote copy sets.
IMPORTANT: You must wait for normalization on all remote copy sets to complete before you
can proceed.
3. Enter a SHOW REMOTE COPY FULL command to see a percentage of completion.
SHOW REMOTE_COPY_SETS FULL
When the units are all normalized, the Target field of the display will be NORMAL.
4. Shut down the target host.
5. Disable access to the target units by using the following CLI command:
SETUnitName DISABLE=(TargetHostConnectionNamex,TargetHostConnectionNamey)
Repeat this step for all units.
6. Delete all association sets by using the following CLI command:
DELETE AssociationSetName