Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide

5–14 Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide
8. For Windows NT, reboot the server, and log in as Administrator. You should be able
to see all of the drives in My Computer.
9. For OpenVMS, if you have shut down the host, boot the host at this time. Booting the
host enables OpenVMS to recognize the drives. If you did not shut down the host, use
the following command from a privileged account to enable OpenVMS to recognize
the drives:
MCR SYSMAN I0 AUTOCONFIGURE/LOG
4. To remove the targets use the following CLI command:
SET RemoteCopySetName REMOVE=InitiatorRemoteCopyName\UnitNumber
Example: SET rcs1 REMOVE=buildngA\d1
Re-create association sets that are on the initiator. Repeat this step for each
association set.
NOTE: Refer to the configuration chapter for information on how to create association sets.
5. Give the target site hosts access to the units in its storage subsystems with this
command:
SET UnitName ENABLE = TargetHostConnectionNamex,TargetHostConnectionNamey
If you do not recall the target host name, use the SHOW CONNECTION
command.
Repeat this step for all units.
6. To verify that the target host can connect to the LUNs, use this command:
SHOW UNITS FULL
In the Access field of the display, all units should show that the target hosts are
enabled. You should also see the connections to the initiator controller.
7. You can enhance host I/O performance by resetting the maximum cached
transfer size to the original value used on the initiator. Use this command:
SET UnitName MAXIMUM_CACHED_TRANSFER_SIZE = initiator value
Proceed to step 8 or 9 depending on your operating system.