Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide

5–12 Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide
Repeat this procedure for each association set.
8. Move the remote copy sets to the new initiator using the following CLI command:
SET RemoteCopySetName INITIATOR=InitiatorRemoteCopyName\UnitName
NOTE: If after issuing this command for one of the Remote Copy Sets you get the error
message: Error: Rem Cp Set specified is currently in a
transient state, wait a few seconds and try again. The command will eventually
succeed.
9. If maximum cached transfer size was changed for the target units as part of the failover
procedure, set it back to 1 with the following CLI command:
SET UnitName MAXIMUM_CACHED_TRANSFER_SIZE=1
Repeat this procedure for each unit.
Initiator Site Clean Up
1. Enable access to the initiator site host by using the following CLI command:
SET UnitName ENABLE=(InitiatorHostConnectionNamex,InitiatorHostConnectionNamey)
2. Optional: Set failsafe by using the following CLI command:
SET RemoteCopySetName ERROR MODE=FAILSAFE
NOTE: Failsafe cannot be set if the remote copy set is within an association set that is to be
used for write history logging.
3. Enable write history logging, if appropriate.
NOTE: Refer to the Configuration chapter for information on how to configure association sets
for write history logging.
4. If you changed an asynchronous remote copy set to synchronous during failover,
change back to asynchronous mode by issuing the following CLI command:
SET RemoteCopySetName OPERATION_MODE=ASYNCHRONOUS
Repeat this step for all applicable remote copy sets.
NOTE: Association Sets do not need to be recreated.
5. For Windows NT reboot the server at the initiator site, and log in as Administrator.
You should be able to see all of the drives in My Computer.