24 Service Manual (AA-RTDXC-TE, July 2004)

Diagnostics

100 Edge Switch 2/24 Service Manual

Beaconing is enabled for the port.

1. Consult the customer and next level of support to determine the reason port

beaconing is enabled.

2. Disable port beaconing.

a. At the Hardware View, right-click the port graphic. A pop-up menu

appears.

b. Click the Enable Beaconing option. The check mark disappears from the

box adjacent to the option, and port beaconing is disabled.

Was port beaconing enabled because port failure or degradation was suspected?

YES NO

↓ The switch appears operational. Exit MAP.

Go to step 1.

As indicated by a message or event code 080, the eight-byte (16-digit) worldwide

name (WWN) entered to configure port binding is not valid or a nickname was

used that is not configured for the attached device in the Element Manager

application.

From the Hardware View, click Node List. Note the Port WWN column. This is

the WWN assigned to the port or Fibre Channel interface installed on the attached

device.

■ If a nickname is not assigned to the WWN, the WWN is prefixed by the

device manufacturer’s name.

■ If a nickname is assigned to the WWN, the nickname appears in place of the

WWN.

The bound WWN must be entered in the form of a raw WWN format

(XX:XX:XX:XX:XX:XX:XX:XX) or must be a valid nickname. Ensure a valid

WWN or nickname is entered.

Did configuring the WWN or nickname solve the problem?

NO YES

↓ The switch appears operational. Exit MAP.

Contact the next level of support. Exit MAP.