24 Service Manual (AA-RTDXC-TE, July 2004)

Diagnostics

97Edge Switch 2/24 Service Manual

Install an SFP optical transceiver in the port receptacle. Refer to “RRP: SFP

Optical Transceiver” on page 195.

■ This procedure is concurrent and can be performed while the switch is

powered on and operational.

■ Verify location of the failed port.

■ Perform an external loopback test for the port as part of FRU removal and

replacement. Refer to “Perform Loopback Tests” on page 160.

Exit MAP.

At the HAFM appliance, does a blinking red and yellow diamond (failed FRU

indicator) appear adjacent to a Fibre Channel port graphic at the Hardware View?

NO YES

↓ A port failure is indicated. Go to step 6.

Did a Fibre Channel port fail a loopback test?

NO YES

↓ Go to step 18.

Does a yellow triangle (attention indicator) appear adjacent to a port graphic at the

Hardware View?

YES NO

↓ Go to step 17.

Invalid Attachment Go to step 22.

Link Reset Go to step 33.

Not Installed Go to step 12.

Table 11: Port Operational States and Actions (EWS) (Continued)

Operational State Action