FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Edge Switch 2/24 Service Manual (AA-RTDXC-TE, July 2004)

Event Codes
263Edge Switch 2/24 Service Manual
Table 46: Event Code 120
Message: Error detected while processing system management command.
Severity: Informational.
Explanation: This event occurs when the switch receives an HAFM command that violates
specified boundary conditions, typically as a result of a network error. The switch
rejects the command, drops the switch-to-HAFM appliance Ethernet link, and forces
error recovery processing. When the link recovers, the command can be retried.
Action: No action is required for an isolated event. If this event persists, perform a data
collection for this switch using the
HAFM application. Perform the data collection
procedure and return the backup disk to Hewlett-Packard support personnel.
Event Data: No supplementary data included with the event.
Distribution: Switch HAFM Appliance Host
EWS
Event
Log
System
Error
LED
Event
Log
E-Mail Call
Home
Sense
Info
Link
Incident
✔✔
Table 47: Event Code 121
Message: Zone set activation failed–zone set too large.
Severity: Informational.
Explanation: This event occurs when the switch receives a zone set activation command that
exceeds the size supported by the switch. The switch rejects the command, drops
the switch-to-HAFM appliance Ethernet link, and forces error recovery processing.
When the link recovers, the command can be modified and retried.
Action: Reduce the size of the zone set to conform to the limit specified, then retry the
activation command.
Event Data: No supplementary data included with the event.
Distribution: Switch HAFM Appliance Host
EWS
Event
Log
System
Error
LED
Event
Log
E-Mail Call
Home
Sense
Info
Link
Incident
✔✔