FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Edge Switch 2/24 Service Manual (AA-RTDXC-TE, July 2004)

Messages
241Edge Switch 2/24 Service Manual
No file was selected. Action requires you to
select a file
Select a file.
No firmware version file
was selected.
A file was not selected in
the Firmware Library
dialog box before an
action, such as modify
or send was performed.
Click a firmware version in
the dialog box to select it,
then perform the action
again.
No firmware versions to
delete.
There are no firmware
versions in the firmware
library to delete.
N/A. An informational
message.
Non-redundant switch
must be offline to install
firmware.
Since the switch has only
a single CTP card, it
must be offline to initiate
a firmware installation.
Note that the CTP card is
an internal component
and not a FRU.
Take switch offline and try
again.
Not all of the optical
transceivers are installed
for this range of ports.
Some ports in the
specified range do not
have optical transceivers
installed.
Use a port range that is
valid for the ports installed.
Open Trunking is not
installed for this product.
Please contact your sales
representative.
The Open Trunking
feature key has not been
enabled. This message
only displays if the
optional Open Trunking
feature is installed.
Enter the feature key into
the Configure Feature Key
dialog box and enable the
key. If you require a feature
key, see your account
representative.
Performing this
operation will change
the current state to
Offline.
This operation causes
the switch to go offline.
N/A. An informational
message.
Performing this
operation will change
the current state to
Online.
This operation causes
the switch to go online.
N/A. An informational
message.
Table 30:
Edge Switch 2/24 Element Manager Messages (Continued)
Message Description Action