FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Edge Switch 2/24 Service Manual (AA-RTDXC-TE, July 2004)

Messages
223Edge Switch 2/24 Service Manual
Password and
confirmation don’t
match.
Entries in the password
field and confirmation
password field do not
match. The entries are
case sensitive and must
be the same.
Enter the password and
confirmation password
again.
Remote session support
has been disabled.
The connection between
the specified remote
workstation and the
HAFM appliance was
disallowed.
Consult with the customer’s
network administrator to
determine if the
workstation entry should be
modified at the Session
Options dialog box.
Remote sessions are not
allowed from this
network address.
Only IP addresses of
remote workstations
specified at the Session
Options dialog box are
allowed to connect to the
HAFM appliance.
Consult with the customer’s
network administrator to
determine if the IP address
is to be configured for
remote sessions.
Resource is unavailable. The specified operation
cannot be performed
because the product is
unavailable.
Verify the HAFM
appliance-to-product link is
up. If the link is up, the
HAFM appliance may be
busy. Retry the operation
later.
Select alias to add to
zone.
An alias was not selected
before clicking Add.
Choose an alias before
clicking Add.
Selection is not a
World-Wide Name.
The selection made is not
a world-wide name.
Select a valid world-wide
name before performing
this operation.
Server shutting down. The
HAFM application is
closing and terminating
communication with the
attached product.
Reboot the HAFM
appliance. If the problem
persists, contact the next
level of support.
SNMP trap address not
defined.
If an SNMP community
name is defined, a
corresponding SNMP
trap recipient address
must also be defined.
Enter a corresponding
SNMP trap recipient
address.
Table 29: HAFM application messages (Continued)
Message Description Action