FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Edge Switch 2/24 Service Manual (AA-RTDXC-TE, July 2004)

Messages
218 Edge Switch 2/24 Service Manual
Error removing zone or
zone member.
The HAFM application
encountered an internal
error.
Try the operation again. If
the problem persists,
contact the next level of
support.
Error transferring files
<message>.
An error occurred while
transferring files from the
PC hard drive to the
HAFM application. The
message varies,
depending on the
problem.
Try the file transfer
operation again. If the
problem persists, contact
the next level of support.
Fabric Log will be lost
once the fabric
unpersists. Do you want
to continue?
When you unpersist a
fabric, the corresponding
Fabric Log is deleted.
Click Yes to unpersist the
fabric or No to cancel the
operation.
Fabric not persisted. The user attempted to
refresh or clear the
Fabric Log after a fabric
was unpersisted. When
you unpersist a fabric,
the corresponding Fabric
Log is deleted.
Click OK to continue.
Ensure the fabric is
persisted before attempting
to refresh or clear the
Fabric Log.
Field cannot be blank. The data field requires an
entry and cannot be left
blank.
Enter appropriate
information in the data
field.
Field has exceeded
maximum number of
characters.
The maximum number of
data entry characters
allowed in the field was
exceeded.
Enter the information using
the proscribed number of
characters.
File transfer aborted. The user aborted the file
transfer process.
Verify the file transfer is to
be aborted, then click OK
to continue.
HAFM management
session is already active
from this workstation.
An HAFM management
session is open and
active at this workstation.
A workstation can have
only one active HAFM
management session.
HAFM error <error
number 1 through 8 >.
The
HAFM application
encountered an internal
error (1 through 8
inclusive) and cannot
continue operation.
Contact the next level of
support to report the
problem.
Table 29: HAFM application messages (Continued)
Message Description Action