FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Edge Switch 2/24 Service Manual (AA-RTDXC-TE, July 2004)

Messages
217Edge Switch 2/24 Service Manual
Duplicate zone member
in zone configuration.
More than one instance
of a zone member is
defined in a zone.
Delete one of the duplicate
zone members from the
zone.
Element Manager
instance is currently
open.
A product cannot be
deleted while an instance
of the
Element Manager
application is open.
Close the
Element Manager
application, then delete the
product.
Enabling this zone set
will replace the currently
active zone set. Do you
want to continue?
Only one zone set can be
active. By enabling the
selected zone set, the
active zone set will be
replaced.
Click OK to continue or
Cancel to end the
operation.
Enterprise Fabrics
feature not installed.
Please contact your sales
representative.
A user selected Fabric
Binding or Enterprise
Fabric Mode from the
Fabrics menu. These
selections are not
enabled because the
optional SANtegrity
Binding feature is not
installed.
Install the optional
SANtegrity Binding feature
to use Fabric Binding or
enable Enterprise Fabric
Mode.
Error creating zone. The
HAFM application
encountered an internal
error.
Try the operation again. If
the problem persists,
contact the next level of
support.
Error creating zone set. The
HAFM application
encountered an internal
error.
Try the operation again. If
the problem persists,
contact the next level of
support.
Error deleting zone. The
HAFM application
encountered an internal
error.
Try the operation again. If
the problem persists,
contact the next level of
support.
Error deleting zone set. The
HAFM application
encountered an internal
error.
Try the operation again. If
the problem persists,
contact the next level of
support.
Error reading log file. The
HAFM application
encountered an error
while trying to read the
log.
Try the operation again. If
the problem persists,
contact the next level of
support.
Table 29: HAFM application messages (Continued)
Message Description Action