FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Edge Switch 2/24 Service Manual (AA-RTDXC-TE, July 2004)

Messages
214 Edge Switch 2/24 Service Manual
Cannot display route.
Error 9.
An internal error
occurred while trying to
show routes.
Retry the operation. If the
condition persists, contact
support personnel and
report the problem.
Cannot display route.
No active zone enabled.
You cannot show the
route through a fabric
with no active zone.
Enable the default zone or
activate a zone set before
attempting to show the
route.
Cannot display route.
All switches in route
must be managed by the
same server.
You cannot show the
route through a fabric
that has switches or
directors that are
managed by a different
HAFM appliance.
This route cannot be shown
unless all Edge Switches
and Directors in the route
are managed by this
HAFM appliance.
Cannot display route.
All switches in route
must support routing.
You cannot show the
route through a fabric
that has switches or
directors which do not
support routing.
The route must contain only
Directors or Edge Switches.
Cannot have spaces in
field.
Spaces are not allowed
as part of the entry for
this field.
Delete spaces from the field
entry.
Cannot modify a zone
set with an invalid
name. Rename zone set
and try again.
A zone set must have a
valid name to be
modified.
Assign a valid name to the
zone set, then click Modify.
Cannot modify a zone
with an invalid name.
Rename zone and try
again.
A zone must have a valid
name to be modified.
Assign a valid name to the
zone, then click Modify.
Cannot modify product. The selected product
cannot be modified.
Verify the HAFM
appliance-to-product link is
up.
If the link is up, the HAFM
appliance may be busy.
Another Element Manager
instance may be open.
The user may not have
permission to modify the
product.
Table 29: HAFM application messages (Continued)
Message Description Action