24 Service Manual (AA-RTDXC-TE, July 2004)

Diagnostics

128 Edge Switch 2/24 Service Manual

Reboot the HAFM appliance and perform system diagnostics.

1. At the Windows 2000 desktop, click Start at the left side of the task bar

(bottom of the desktop), then click Shut Down. The Shut Down Windows

dialog box displays.

2. Click the Shut Down option from the list box and click OK. The HAFM

appliance powers down.

3. Wait approximately 30 seconds and press the power ( ) button on the LCD

panel to power on the HAFM appliance and perform POSTs. During POSTs:

a. The green LCD panel illuminates.

b. The green HDD LED blinks momentarily, and processor speed and

random-access memory information display momentarily at the LCD

panel.

c. After a few seconds, the LCD panel displays the following message

pertaining to boot sequence selection (Figure 35):

Figure 35: LCD Panel During Boot Sequence

d. Ignore the message. After ten seconds, the HAFM appliance performs the

boot sequence from BIOS. During the boot sequence, the HAFM

appliance performs additional POSTs and displays the following

operational information at the LCD panel:

—Host name.

— System date and time.

— LAN 1 and LAN 2 IP addresses.

— Fan rotational speed.

— CPU temperature.

— Hard disk capacity.

— Virtual and physical memory capacity.

4. After successful POST completion, the LCD panel displays a Welcome!!

message, then continuously cycles through and displays HAFM appliance

operational information.

Boot from LAN?

Press <Enter>