24 Service Manual (AA-RTDXC-TE, July 2004)

Diagnostics

118 Edge Switch 2/24 Service Manual

4. At the Hardware View for the first switch reporting the problem, click

Configure > Operating Parameters > Switch Parameters. The Configure

Switch Parameters dialog box displays (Figure 31).

Figure 31: Configure Switch Parameters dialog box

5. Type the customer-determined preferred domain ID value, then click

Activate.

6. Repeat steps d and e at the Hardware View for the switch attached to the

segmented E_Port (second switch). Use a different preferred domain ID value.

7. Set both switches online. Refer to “Set the Switch Online or Offline” on

page 174.

Did the domain ID change solve the problem and did both switches join through

the ISL to form a fabric?

NO YES

↓ The switch, associated ISL, and multiswitch fabric appear

operational. Exit MAP.

Contact the next level of support. Exit MAP.

A switch E_Port segmented because two switches had incompatible zoning

configurations. An identical zone name is recognized in the active zone set for

both switches, but the zones contain different members.

1. Work with the system administrator to determine the desired zone name

change for one of the affected switches. Zone names must conform to the

following rules:

— The name must be 64 characters or fewer in length.

— The first character must be a letter (a through z), upper or lower case.