24 Service Manual (AA-RTDXC-TE, July 2004)

Diagnostics

103Edge Switch 2/24 Service Manual

Figure 25: Configure Fabric Parameters dialog box

3. Choose the operating mode as follows:

■ Choose Open Fabric 1.0 from the Interop Mode list box.

■ Choose Homogeneous from the Interop Mode list box.

4. Click Activate to save the selection and close the window.

Did configuring the operating mode solve the problem?

NO YES

↓ The switch appears operational. Exit MAP.

Contact the next level of support. Exit MAP.

A loopback (wrap) plug appears to be connected to the port and there is no

diagnostic test running. Is a loopback plug in the port receptacle?

YES NO

↓ Contact the next level of support. Exit MAP.

Remove the loopback plug from the port receptacle. If directed by the customer,

connect a fiber-optic cable attaching a device to the switch.

■ If the port is operational and a device is not attached, both LEDs adjacent to

the port extinguish and the port state is No Light.

■ If the port is operational and a device is attached, the blue or green LED

illuminates, the amber LED extinguishes, and the port state is Online.

Did removing the loopback plug solve the problem?

NO YES

↓ The switch appears operational. Exit MAP.

Contact the next level of support. Exit MAP.