24 Installation Guide (AA-RTDWC-TE, July 2004)

Installing and Configuring the Edge Switch 2/24

87Edge Switch 2/24 Installation Guide

7. Perform either of the following steps:

■ If you need to change any parameters, click Previous or Next to display

the desired Modify Threshold screen.

■ Click Finish when you are done.

Activate or Deactivate Alerts

Use the following steps to activate or deactivate existing threshold alerts. In the

active state, notifications are generated for the alert. In the inactive state,

notifications do not occur.

1. At the Hardware View page, choose Configure > Threshold Alerts. The

Configure Threshold Alerts dialog box displays.

The port’s current state, inactive or active, is listed under the State column.

2. To change the state, choose the alert by the alert information in the table.

3. If the alert is active, choose Deactivate to change to the inactive state. If the

alert is inactive, choose Activate to change to the active state.

Delete Alerts

Use the following steps to delete existing threshold alerts.

1. At the Hardware View page, choose Configure > Threshold Alerts. The

Configure Threshold Alerts dialog box displays.

2. Select the alert that you want to delete by selecting the alert information in the

table and click Delete. A message displays asking you to confirm the deletion.

3. Click Yes. The alert is removed from the dialog box.

Test Remote Notification

4. At the Product View page, choose Maintenance > Test Remote

Notification. The Test Remote Notification dialog box displays (Figure 33).

Figure 33: Test Remote Notification dialog box