24 Installation Guide (AA-RTDWC-TE, July 2004)

Installing and Configuring the Edge Switch 2/24

86 Edge Switch 2/24 Installation Guide

12. Click Finish. The Configure Threshold Alerts dialog box displays listing the

name, type, and state of the alert that you just configured.

13. At this point, the alert is not active. To activate the alert, choose the alert

information that displays in the Configure Threshold Alerts table and click

Activate. The alert is activated as shown in Figure 32.

Figure 32: Configure Threshold Alerts dialog box—alert activated

Modify Alerts

Use the following steps to modify an existing threshold alert configuration.

1. At the Hardware View page, choose Configure > Threshold Alerts. The

Configure Threshold Alerts dialog box displays.

Select the alert that you want to modify by clicking the alert information in

the table. If the alert is active, an error message displays prompting you to

deactivate the alert.

2. If the alert is active, click Deactivate, then choose the alert information in the

table again.

3. Click Modify. An initial Modify Threshold screen displays where you can

change the threshold type.

4. Select a threshold type from the drop-down list.

5. Click Next when you are done. A Modify Threshold screen displays where

you can change the % utilization, cumulative minutes for the threshold to

occur before notification, and the time interval for measuring throughput and

for alert notification.

6. Make appropriate changes, then continue through the Modify Threshold

screens, making changes as necessary, until the summary screen displays the

alert configuration.