24 Installation Guide (AA-RTDWC-TE, July 2004)

Installing and Configuring the Edge Switch 2/24

76 Edge Switch 2/24 Installation Guide

3. Click Add. The Add Preferred Path dialog box displays (Figure 21).

Figure 21: Add Preferred Path dialog box

4. At the Source Port field, type a value between 0 through 23. For this switch,

the value uniquely identifies the starting port for the preferred path.

5. At the Exit Port field, type a value between 0 through 23. For

this switch, the value uniquely identifies the exit port for the preferred path.

6. At the Destination Domain ID field, type a value between 1 through 31. This

value uniquely identifies the destination director or switch in the path.

7. Click OK to close the Add Preferred Path dialog box and add the path to the

list at the Configure Preferred Paths dialog box.

8. Repeat step 3 through step 7 to configure additional preferred paths.

9. At the Configure Preferred Paths dialog box, select (click) the Enable

Preferred Path check box.

10. Click Activate to enable all configured preferred paths and close the dialog

box.

Configure SNMP Trap Message Recipients

Perform this procedure to configure community names, write authorizations, and

network addresses and for up to 12 SNMP trap message recipients on the HAFM

appliance. A trap recipient is a management workstation that receives notification

(through SNMP) if a switch event occurs.