24 Installation Guide (AA-RTDWC-TE, July 2004)

Installing and Configuring the Edge Switch 2/24

57Edge Switch 2/24 Installation Guide

10. Change the IP address, subnet mask, and gateway address as directed by the

customer’s network administrator. To change switch network addresses, enter

the following at the C> prompt:.

ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz

The IP address is always xxx.xxx.xxx.xxx, the subnet mask is always

yyy.yyy.yyy.yyy, and the gateway address is always

zzz.zzz.zzz.zzz, where the octets xxx, yyy, and zzz are decimals

from zero through 255. If a network address is to remain unchanged, enter the

current address in the respective field.

When the new network addresses are configured at the switch, the message

Request completed OK displays at the bottom of the

Edge Switch 2/24 — HyperTerminal window.

11. Choose File > Exit to close the HyperTerminal window. A message box

displays (Figure 11).

Figure 11: Disconnect Now dialog box

12. Click Yes. A message box displays (Figure 12).

Figure 12: Save Session dialog box

13. Click No to exit and close the HyperTerminal dialog box.

14. Power off the maintenance terminal:

a. Choose Start > Shut Down. The Shut Down Windows dialog box

displays.

b. Choose Shut down the Computer and click Ye s to power off the PC.

15. Disconnect the RS-232 null modem cable from the switch and the

maintenance terminal. Replace the protective plate over the maintenance port.