24 Installation Guide (AA-RTDWC-TE, July 2004)

Installing and Configuring the Edge Switch 2/24

56 Edge Switch 2/24 Installation Guide

7. Configure the Port Settings parameters as follows:

— Bits per second — 115200

— Data bits — 8

— Parity — None

— Stop bits — 1

— Flow control — Hardware

When the parameters are set, click OK. The HyperTerminal window displays.

8. At the > prompt, enter the user-level password (the default is password). The

password is case sensitive. The HyperTerminal window displays with a C>

prompt at the top of the window (Figure 10).

Figure 10: HyperTerminal window

9. At the C> prompt, enter ipconfig. The HyperTerminal window displays

with configuration information listed as follows:

— MAC Address

— IP Address (default is 10.1.1.10, factory preset is 10.1.1.10)

— Subnet Mask (default is 255.0.0.0).

— Gateway Address (default is 0.0.0.0)

Only the IP Address, Subnet Mask, and Gateway Address fields are

configurable.