24 Installation Guide (AA-RTDWC-TE, July 2004)

Installing and Configuring the Edge Switch 2/24

51Edge Switch 2/24 Installation Guide

Install the Edge Switch on a Desktop

To install and configure the Edge Switch on a desktop:

1. Remove the backing from the four adhesive rubber pads and apply the pads to

the underside of the Edge Switch.

2. Ensure that the pads are aligned with the scribed circles at each corner.

3. Position the Edge Switch on a table or desktop as directed by the customer.

Ensure that:

■ Grounded AC electrical outlets are available.

■ Adequate ventilation is present.

■ Areas with excessive heat, dust, or moisture are avoided.

■ All planning considerations are met. Refer to the HP StorageWorks

HA-Fabric Manager User Guide.

4. Verify all field-replaceable units (FRUs), including small form factor

pluggable (SFP) optical transceivers and combined cooling fan and power

supply assemblies, are installed as ordered.

5. Connect the U.S. or country-specific (optional) AC power cords to the right

(PS0) and left (PS1) receptacles at the rear of the chassis.

WARNING: An HP-supplied power cord is provided for each Edge Switch

power supply. To prevent electric shock when connecting the Edge Switch to

primary facility power, use only the supplied power cords, and ensure that

the facility power receptacle is the correct type, supplies the required voltage,

and is properly grounded.

6. Connect the remaining ends of the AC power cords to separate facility power

sources that provide single-phase, 90 to 264 volt alternating current (VAC)

current. This provides power redundancy.

When the first power cord is connected, the Edge Switch powers on and

performs power-on self-tests (POSTs). During POSTs:

a. The green power (PWR) LED on the front panel illuminates.

b. The amber system error (ERR) LED on the front panel blinks

momentarily while the Edge Switch is tested.

c. The green LEDs associated with the Ethernet port blink momentarily

while the port is tested.