24 Installation Guide (AA-RTDWC-TE, July 2004)

Rack Mount Instructions

45Edge Switch 2/24 Installation Guide

Installing the Switch in the Cabinet

Use these steps to install the switch in the cabinet. You will need a #2 Phillips

screwdriver and two rear spacing brackets to complete this procedure.

1. From the front side of the cabinet, slide the switch into the mounting brackets

and along the rails until the rear of the switch is flush with the rear of the

cabinet.

2. Bring the rear spacing brackets to the rear of the cabinet.

3. Pull the switch toward the rear of the cabinet until it protrudes approximately

3 inches.

4. Orient the rear spacing bracket mounts so that they are pointed outward. Insert

the tabs on each rear spacing bracket into the designated slots in each rail.

5. Push the switch forward using both rear spacing brackets until the rear

spacing bracket mounts contact the cabinet rail.

6. Attach the rear spacing brackets to the cabinet using two Phillips panhead

screws (10-32 x 5/8) with flat washer.

7. Ensuring that the square alignment washers are seated properly within the

square cabinet frame holes, use a Phillips head screwdriver to tighten the rear

and front mounting screws.