24 Installation Guide (AA-RTDWC-TE, July 2004)

Rack Mount Instructions

40 Edge Switch 2/24 Installation Guide

Rack Mount Checklist

This section describes the contents of the rack mount kit as well as tools or

equipment required to complete the installation.

Note: The hardware kit includes parts not required for the configuration described in

these instructions.

Mounting Hardware

■ Two (2) two-hole bar nuts

■ Six (6) three-hole bar nuts (only 4 used)

■ Eight (8) square alignment washers (required only for HP 9000, 10000 and

11000 series racks)

■ Eight (8) Phillips panhead screws (10-32 x 1/2) with split lock and flat

washers

■ Four (4) Phillips flathead screws (8-32 x 7/16)

■ Ten (10) Phillips panhead screws (10-32 x 5/8) with flat washer (only 2 used)

■ Six (6) Phillips flathead screws (6-32 x 3/8) (not used)

■ Twelve (12) Phillips panhead screws (10-32 x 3/8) (not used)

■ Four (4) 8-32 Keps nuts (not used)

Brackets and Rails

Brackets and rails included in the kit are shown in Figure 5.

1 Two (2) fixed-length slide rails (one left and one right)

2 Two (2) Front brackets

3 Two (2) Rear brackets (long)

4 Two (2) Rear spacing bracket

5 Rear bracket (short)–not used in this configuration