24 Installation Guide (AA-RTDWC-TE, July 2004)

Using the Embedded Web Server

111Edge Switch 2/24 Installation Guide

Enable or Disable the CLI

Perform this procedure to toggle (enable or disable) the state of the switch’s

command line interface. To change the CLI state:

1. Choose Configure > Management > CLI to display the CLI tab (Figure 46).

Figure 46: Management page—CLI tab

2. Perform one of the following steps as required:

— Click Enable to activate the CLI. The message “Your changes to

the CLI enable state have been successfully

activated” displays.

— Click Disable to deactivate the CLI. The message “Your changes to

the CLI enable state have been successfully

activated” displays.