24 Installation Guide (AA-RTDWC-TE, July 2004)

Using the Embedded Web Server

107Edge Switch 2/24 Installation Guide

Configure Network Information

Verify that the type of LAN installation with the customer’s network

administrator. If one switch is installed on a dedicated LAN, network information

(IP address, subnet mask, and gateway address) does not require change. Go to

“Configure Switch Ports” on page 98.

If multiple switches are installed, or a public LAN segment is used, network

information must be changed to conform to the customer’s LAN addressing

scheme. Perform one of the following:

■ If network information was changed while performing “Configure Switch

Network Information” on page 53, this procedure is not required. Go to

“Configure SNMP Trap Message Recipients” on page 108.

■ If network information was not changed, perform the following steps to

change a switch IP address, subnet mask, or gateway address:

1. Choose Configure > Switch > Network to display the Network tab

(Figure 43).

Figure 43: Switch page—Network tab

a. At the IP Address field, enter the new value as specified by the network

administrator (default (factory preset) is 10.1.1.10).

b. At the Subnet Mask field, enter the new value as specified by the

network administrator (default is 255.0.0.0).

c. At the Gateway Address field, enter the new value as specified by the

network administrator (default is 0.0.0.0).

2. Click Activate to save the information. The following message box displays

(Figure 44).