24 Installation Guide (AA-RTDWE-TE, November 2005)

Table Of Contents

Installing the Edge Switch26

NOTE: The hardware kit includes parts not required for the configuration described in these

instructions.

Brackets and rails

Figure 6 shows the brackets and rails included in the rack mount kit.

Figure 6 Brackets included in kit

Required tools

The following tools are required, but are not included in the kit:

• Torque driver with a T10 Torx bit

• #2 Phillips screwdriver

Mounting the adjustable brackets in the rack

Tools and equipment required:

• One #2 Phillips screwdriver

1 Two fixed-length slide rails (one left

and one right)

2 Two front brackets

3 Two rear brackets (long)

4 Two rear spacing brackets

5 Rear bracket (short)---not used in this

configuration