FW 08.01.00/HAFM SW 08.06.xx or later HP StorageWorks Edge Switch 2/24 Installation Guide (AA-RTDWE-TE, November 2005)
Table Of Contents
- Edge Switch 2/24 installation guide
- Contents
- Introduction to the Edge Switch 2/24
- Installing the Edge Switch
- Connecting the Edge Switch
- Edge Switch network addresses
- LAN-connecting the Edge Switch
- Setting up the HAFM appliance
- Using HAFM to configure the Edge Switch
- Setting the Edge Switch online and offline
- Configuring Edge Switch identification
- Configuring Edge Switch operating parameters
- Configuring fabric operating parameters
- Configuring switch binding
- Configuring preferred path
- Configuring ports
- Configuring SNMP trap message recipients
- Configuring, enabling, and testing e-mail notification
- Configuring and enabling call-home features
- Configuring and enabling Ethernet events
- Configuring, enabling, and testing call-home event notification
- Threshold alerts
- Creating new alerts
- Figure 30 Configure Threshold Alerts dialog box
- Figure 31 New Threshold Alerts dialog box-first screen
- Figure 32 New Threshold Alerts dialog box-second screen
- Figure 33 New Threshold Alerts dialog box-third screen
- Figure 34 New Threshold Alerts dialog box-summary screen
- Figure 35 Configure Threshold Alerts dialog box-alert activated
- Modifying alerts
- Activating or deactivating alerts
- Deleting alerts
- Creating new alerts
- Configuring SANtegrity Authentication
- Backing up HAFM configuration data
- Resetting configuration data
- Enabling the HAFM Basic interface
- Enabling Telnet
- Connecting the Edge Switch to a fabric
- Using the HAFM Basic interface
- Launching the HAFM Basic interface
- Setting the Edge Switch offline and online
- Configuring Edge Switch ports
- Configuring BB credit
- Configuring Edge Switch identification
- Configuring date and time
- Configuring Edge Switch parameters
- Configuring network information
- Configuring SNMP trap message recipients
- Enabling or disabling the CLI
- Configuring zoning
- Managing firmware versions
- Regulatory compliance and safety
- Technical specifications
- Index
Edge Switch 2/24 installation guide 127
rerouting delay 45
setting date and time 38
tools supplied 20
unpacking and inspecting 24
verifying communication to HAFM appliance 37
switch binding
configure
HAFM Basic 87
description 87
enable
HAFM Basic 87
switch firmware
adding version 92
deleting a version 95
downloading 95
version 91
switch parameters
domain RSCNs 45
insistent domain ID 45
NVRAM storage 43, 46
preferred domain ID 44
rerouting delay 45
suppress RSCNs on zone set activations 45
symbols in text 10
system
preventing electrostatic discharge to 105
T
Taiwan EPA battery recycling and disposal 104
technical specifications, power requirements 118
technical support, HP 11
telephone numbers
FCC questions 100
Telnet, enabling 65
text symbols 10
toe straps, using 105
tools
and test equipment 20
required for rack mounting 26
supplied by service personnel 21
supplied with switch 20
tools, conductive type 105
trap recipient IP addresses, default value 116
U
UDP port, default value 116
V
versions
firmware
deleting 95
determining 91
modifying description 94
Windows operating systems 21
voltage compliance rating 104
W
warning
rack stability 11
warnings
alkaline batteries 104
battery replacement 104
lasers, radiation 101
waste electrical and electronic equipment directive
106
waste equipment disposal for EU private households
107
web sites
HP storage 12
HP Subscriber’s choice 11
Windows operating systems, versions 21
work mat, static-dissipating 105
wrist straps
specifications 105
using 105
WWN
principal switch 47
Z
zone sets
default value 117
description 89
description of 16
zones
description 89
members, default value 117
number of, default value 117
set state, default value 117
states, default value 117
zoning, default values 117