FW 08.01.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-330, November 2005)

Installation Tasks

2-23

Installation Tasks

Enable CLI

Perform this procedure to toggle (enable or disable) the state of the

product’s command line interface. To change the CLI state:

1. Select CLI from the Configure menu at any view. The CLI View

displays (Figure 2-11).

Figure 2-11 CLI View

2. Perform one of the following:

•Click Enable to activate the CLI.

•Click Disable to deactivate the CLI.

3. Click (check) the Use SSH check box to enable secure shell (SSH)

protocol. The protocol controls CLI access to the product and

provides software-enforced encryption.

4. Click OK to save and activate changes.

Enable or Disable

Host Control

Perform this procedure to configure the open systems management

server and enable OSI host control of the product. Implementing and

enabling OSI host control requires installation of a SAN management

application on the OSI server. Applications include Veritas

SANPoint™ Control or Tivoli

NetView

. To enable or disable OSMS

host control:

1. Select OSMS from the Configure menu at any view. The OSMS

View displays (Figure 2-12).