FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

D-4
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
IP addresses are structured to represent a location and product type.
The address format is 010.rrr.ppp.xxx, where:
• rrr is the cabinet number (001, 002, or 003), which specifies the
location of a stand-alone product or McDATA FC-512 Fabricenter
equipment cabinet. The numbers have no hierarchical
significance and do not have to reflect physical order along a
LAN. However, you must assign a different number to each
stand-alone product or cabinet.
NOTE: Procedures in this appendix assume the cabinet at location 1
(001) is associated with the management server, and cabinets connected
to client servers are numbered in the physical order shown in Figure D-3.
• ppp is the product type as follows:
— 001 for a rack-mount management server.
— 003 for an ES-1000 Switch.
— 005 for an ED-5000 Director.
— 006 for an ES-3016 Switch.
— 007 for an ES-3032 Switch.
— 008 for an Intrepid 6064 Director.
— 009 for a Sphereon 3216 Switch.
— 010 for a Sphereon 3232 Switch.
— 011 for an Intrepid 6140 Director.
— 012 for a Sphereon 4500 Switch.
• xxx is the physical position (top to bottom) of the server, director,
or switch in a Fabricenter equipment cabinet as follows:
— 001 for a rack-mount management server.
— 001 for the lowest director or switch of the first model, 002 for
the next director or switch of the same model.
— 001 for the lowest director or switch of the second model, 002
for the next director or switch of the same model.
NOTE: Use position number 001 for stand-alone directors or switches.