FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

ManualsBrandsHP ManualsStorageHP StorageWorks Edge Switch 2/24

491

492

493

494

495

496

497

498

499

500

Restore EFC Server

C-3

4. After the restore process completes, the server makes an

audible series of beeps. Remove the Management Server Restore

CD-ROM from the CD-RW drive.

5. Power cycle the management server. The server performs

power-on self-tests (POSTs). After successful POST completion,

the LCD panel displays a Welcome!! message, then continuously

cycles through and displays server operational information.

6. Configure the following parameters at the server’s LCD panel.

Refer to Task 7: Configure Server Password and Network Addresses on

page 2-51 for instructions.

• LCD panel password.

• IP address for private and public LAN connections.

• Subnet mask or private and public LAN connections.

7. Log on to the server’s Windows 2000 desktop through a LAN

connection to a browser-capable PC. Refer to Access the

Management Server Desktop on page 2-55 for instructions.

8. Configure Windows 2000 configuration information as required

by the customer:

• Configure computer and workgroup names for the

management server. If required, change the server’s gateway

address and DNS server IP address to conform to the

customer’s LAN addressing scheme. Refer to Task 8: Configure

Management Server Information on page 2-55 for instructions.

• Change the default Windows 2000 administrator password

and configure password access for authorized users. Refer to

Task 9: Configure Windows 2000 Users on page 2-63 for

instructions.

• Set the server’s date and time. Refer to Task 10: Set Management

Server Date and Time on page 2-69 for instructions.

• Configure the call-home feature. Refer to Task 11: Configure the

Call-Home Feature (Optional) on page 2-71 for instructions.

9. Insert the EFC Management Applications CD-ROM in the

CD-RW drive and close the LCD panel.

10. At the management server’s Windows 2000 desktop, click Start at

the left side of the task bar, then select the Run option. The Run

dialog box displays (Figure C-1 on page C-4).