FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

A-4
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Message Cannot enable beaconing on a failed FRU.
Description Message occurs when selecting Enable Beaconing for a failed FRU.
Action Replace the FRU and enable beaconing or enable beaconing on an
operating FRU.
Message Cannot enable beaconing while the system error light is on.
Description Beaconing cannot be enabled while the system error LED is
illuminated.
Action Select Clear System Error Light from the Products menu to clear the
error light, then enable beaconing.
Message Cannot enable OpenTrunking while Enterprise Fabric Mode is
active and the switch is offline.
Description Enterprise Fabric Mode is active, the switch is offline, and a user is
attempting to enable OpenTrunking feature. This message displays
only if the feature is installed.
Action Perform one of the following:
•Disable Enterprise Fabric Mode by selecting the appropriate fabric
at the fabric tree portion of the Fabrics view. Open the Enterprise
Fabric Mode dialog box, click Start, and follow the prompts to
disable the feature.
• Set the director or switch online through the Set Online State
dialog box.
Message Cannot have E_Ports if Management Style is FICON unless
SANtegrity feature is installed. Contact your sales representative.
Description Firmware level is below 6.0 and user attempted to change Open
Systems to FICON with E_ports enabled but without the SANtegrity
feature installed.
Action Informational message. If the firmware is below 6.0, if you install
SANtegrity Binding feature before changing to FICON Managment
style, the E_Ports will remain E_Ports when you change to FICON
Management style. If SANtegrity Binding feature is not installed,
setting a director to FICON Managment style will change all E_Ports
to G_Ports.