FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

Messages
A-3
C
Message Cannot change port type while Management Style if FICON,
without SANtegrity Feature. Please contact your sales
representative.
Descripton Firmware level is below 6.0 and user attempted to change a port type
in the Configure Ports dialog box while FICON management style is
enabled, but the optional SANtegrity Binding feature is not installed.
Action Informational message. If the firmware is below 6.0, install
SANtegrity Binding feature before changing port types inthe
Configure Ports dialog box while using FICON Managment style.
Message Cannot create partition <partition number> while FICON
Managment Server is enabled.
Description The user has moved slots into a partition while the FMS server is
enabled.
Action Disable FMS before moving slots into a partition.
Message Cannot disable switch binding while Enterprise Fabric Mode is
active and the switch is online.
Description The user attempted to disable switch binding through the Switch
Binding Change State dialog box, but Enterprise Fabric Mode is enabled.
Action Either disable Enterprise Fabric Mode using the Enterprise Fabric Mode
dialog box at the SAN management application, or set the switch
offline to disable switch binding.
Message Cannot disable Insistent Domain ID while fabric binding is active.
Description The user attempted to disable the Insistent Domain ID parameter
through the Configure Switch Parameters dialog box, but fabric binding
is enabled.
Action Disable fabric binding through the Fabric Binding dialog box before
disabling the parameter.