FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

FRU Removal and Replacement
5-5
c. Insert the keyed LC cable connector into the port’s optical
transceiver.
5. Ensure the amber LED adjacent to the port transceiver is
extinguished. If the amber LED is illuminated, go to MAP 0000:
Start MAP on page 3-6 to isolate the problem.
6. Perform one of the following to inspect the Event Log:
— If at a web browser connected to the SANpilot interface, click
the Log tab at the Monitor panel. The Event Log displays.
Ensure an event code 510 (SFP optics hot-insertion initiated)
appears. If the event code does not appear, go to MAP 0000:
Start MAP on page 3-6 to isolate the problem.
— If at the management server, open the Hardware View, click
Logs, and select Event Log. The Event Log displays. Ensure an
event code 510 (SFP optics hot-insertion initiated) appears. If
the event code does not appear, go to MAP 0000: Start MAP on
page 3-6 to isolate the problem.
7. Perform one of the following to verify port operation:
— If at a web browser connected to the SANpilot interface, open
the Switch tab at the View panel and:
a. Ensure no amber LEDs illuminate that indicate a port
failure.
b. Click the graphic representing the port with the
replacement transceiver to open the Port Properties tab.
Verify port and port technology information is correct.
c. If a problem is indicated, go to MAP 0000: Start MAP on
page 3-6 to isolate the problem.
— If at the management server, open the Hardware View and:
a. Ensure no alert symbols appear that indicate a port failure
(yellow triangle or red diamond).
b. Double-click the graphic representing the port with the
replacement transceiver to open the Port Properties dialog
box. Verify port information is correct.
c. Right-click the graphic representing the port with the
replacement transceiver and select Port Technology from the
menu. The Port Technology dialog box displays. Verify port
technology information is correct.