FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

4-86
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
d. Select (highlight) the entry representing the reset switch in the
Available Addresses window and click Change. The Domain
Information dialog box displays (Figure 4-78).
Figure 4-78 Domain Information Dialog Box
e. Type 10.1.1.10 in the IP Address field and click OK. Entries at
the Discover Setup dialog box reflect the new IP address.
f. At the Discover Setup dialog box, click OK. Switch-to-
management server communication is restored and the
procedure is complete.
10. Change the switch IP address and restart the management server
session as follows:
a. A grey square with a yellow exclamation mark appears
adjacent to the icon representing the reset switch, indicating
switch is not communicating with the management server.
a. Delete the icon representing the reset switch. At the SAN
management application, select the Setup option from the
Discover menu. The Discover Setup dialog box displays
(Figure 4-77 on page 4-85).
b. Select (highlight) the entry representing the reset switch in the
Available Addresses window and click Remove.
c. At the Discover Setup dialog box, click OK. The switch is no
longer defined to the management server.
d. Change a switch’s IP address through the maintenance port at
the rear of the switch. For instructions, refer to Task 5: Configure
Switch Network Information (Optional) on page 2-41.