FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

4-84
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Reset Configuration
Data (Management
Server)
To reset switch data to the factory default settings from the
management server (Sphereon 4500 Element Manager application):
NOTE: When switch configuration data is reset to factory default values, all
optional features are disabled.
1. Notify the customer the switch is to be set offline. Ensure the
customer’s system administrator quiesces Fibre Channel frame
traffic through the switch and sets attached FC-AL devices
offline.
2. At the management server, open the SAN management
application (SANavigator 4.0 or EFCM 8.0).
3. Set the switch offline. For instructions, refer to Set the Switch
Online or Offline on page 4-48.
4. At the SAN management application’s physical map, right-
click the product icon representing the switch for which a
configuration file is to be reset to factory default settings, then
select Element Manager from the pop-up menu. The application
opens.
5. Select the Reset Configuration option from the Maintenance menu.
The Reset Configuration dialog box displays (Figure 4-76).
Figure 4-76 Reset Configuration Dialog Box
6. Click Reset to initiate the reset operation and close the dialog box.
7. The switch IP address resets to the default address of 10.1.1.10.
— If the configured IP address (prior to reset) was the same as
the default address, the switch-to-management server
Ethernet link is not affected and the procedure is complete.