FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

4-82
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Reset Configuration
Data (SANpilot
Interface)
To reset switch data to the factory default settings from the SANpilot
interface:
NOTE: When switch configuration data is reset to factory default values, all
optional features are disabled.
1. Notify the customer the switch is to be set offline. Ensure the
customer’s system administrator quiesces Fibre Channel frame
traffic through the switch and sets attached FC-AL devices
offline.
2. Set the switch offline. For instructions, refer to Set the Switch
Online or Offline on page 4-48.
3. When the SANpilot interface opens, the View panel and Switch
page appear as the default. At the View panel, select the Operations
option at the left side of the panel. The Operations panel opens
with the Switch page displayed.
4. Click the Reset Config tab. The Switch page displays with the Reset
Config tab selected (Figure 4-74).
Figure 4-74 Operations Panel (Switch Page with Reset Config Tab)