FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

3-116
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Did diagnostic test programs detect a problem?
NO YES
↓ Refer to the supporting documentation shipped with the
server for instructions to resolve the problem. Exit MAP.
10
Reboot the server.
a. At the Windows 2000 desktop, click Start at the left side of the
task bar (bottom of the desktop), then select Shut Down. The
Shut Down Windows dialog box displays (Figure 3-46 on
page 3-113).
b. Select the Shut Down option from the list box and click OK. The
management server powers down.
c. Wait approximately 30 seconds and press the power ( ) button
on the LCD panel to power on the server and perform POSTs.
During POSTs:
1. The green LCD panel illuminates.
2. The green HDD LED blinks momentarily, and processor
speed and random-access memory information display
momentarily at the LCD panel.
3. After a few seconds, the LCD panel displays the following
message pertaining to boot sequence selection
(Figure 3-49):
Figure 3-49 LCD Panel During Boot Sequence
4. Ignore the message. After ten seconds, the server performs
the boot sequence from BIOS. During the boot sequence, the
server performs additional POSTs and displays the following
operational information at the LCD panel:
•Host name.
• System date and time.
• LAN 1 and LAN 2 IP addresses.
• Fan 1, fan 2, fan 3, and fan 4 rotational speed.
Boot from LAN?
Press <Enter>