FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

xxviii
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
ATTENTION ! Do not remove a power supply unless a replacement FRU is
immediately available. To avoid product overheating, a removed power
supply must be replaced within five minutes.
ATTENTION ! A reset should only be performed if a CTP card failure is
indicated. Do not reset a managed product unless directed to do so by a
procedural step or the next level of support.
ATTENTION ! This procedure deletes all data from the C: hard
drive partition.
ATTENTION ! Contents of the data directory are backed up to the
management server’s CD-RW drive when directory contents change. To
ensure trouble-free backups, always leave a CD in the drive. Ensure data
is not being written to or read from the CD-RW drive before removing the
CD. Removing the CD during a backup or restore operation can corrupt data.
General Precautions When installing or servicing the switch, follow these practices:
• Always use correct tools.
• Always use correct replacement parts.
• Keep all paperwork up to date, complete, and accurate.
ESD Precautions All electrostatic discharge (ESD) sensitive components and FRUs
in the switch are enclosed and shielded. ESD procedures are not
required when working with the switch.