FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

3-84
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Did reconfiguring the port type solve the problem?
NO YES
↓ The switch appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
24
One of the following mode-mismatch conditions was detected and an
ISL connection is not allowed:
• The switch is configured for operation in Open Fabric 1.0 mode
and is connected to a fabric element not configured to Open
Fabric 1.0 mode.
• The switch is configured for operation in Open Fabric 1.0 mode
and is connected to a legacy McDATA switch at the incorrect
Exchange Link Parameter (ELP) revision level.
• The switch is configured for operation in Open Fabric 1.0 mode
and is connected to a non-McDATA switch at the incorrect ELP
revision level.
• The switch is configured for operation in McDATA Fabric 1.0
mode and is connected to a non-McDATA switch.
Reconfigure the switch operating mode:
a. Ensure the switch is set offline. Refer to Set the Switch Online or
Offline on page 4-48.
b. At the Hardware View (Figure 3-10 on page 3-20), click
Configure and select Operating Parameters and Fabric
Parameters. The Configure Fabric Parameters dialog box
displays (Figure 3-35).