FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

3-76

McDATA Sphereon 4500 Fabric Switch Installation and Service Manual

Is fault isolation being performed at the switch?

YES NO

↓ Fault isolation is being performed at the SANpilot interface,

management server, or customer-supplied server. Go to

step 7.

Each port has an amber LED and a blue (2 Gbps operation) or green

(1 Gbps operation) LED adjacent to the port. The amber LED

illuminates and the blue or green LED extinguishes if the port fails.

Is an amber port LED illuminated but not blinking (beaconing)?

YES NO

↓ The switch appears operational, however a link incident

or other problem may have occurred. Perform fault isolation

at the management server or customer-supplied server.

Go to step 13.

As indicated by a message or event code 506, 512, or 514, a Fibre

Channel port failed and the SFP optical transceiver must be removed

and replaced. Refer to RRP 1: SFP Optical Transceiver on page 5-2.

• This procedure is concurrent and can be performed while the

switch is powered on and operational.

• Verify location of the failed port.

• Replace the optical transceiver with a transceiver of the same

type (shortwave or longwave).

583 Loss of signal or loss of synchronization. Go to step 34.

584 Not operational primitive sequence received. Go to step 34.

585 Primitive sequence timeout. Go to step 34.

586 Invalid primitive sequence received for current link state. Go to step 34.

Table 3-9 MAP 600 Event Codes (Continued)

Event

Code

Explanation Action