FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

Diagnostics
3-73
13
A Page cannot be found, Unable to locate the server, HTTP
404 - file not found, or other similar message appears. The message
indicates the PC cannot communicate with the switch because:
• The switch-to-PC Internet link could not be established.
• AC power distribution in the switch failed, or AC power was
disconnected.
• The switch CTP card failed.
The SANpilot interface is not operational and fault isolation must be
performed at the switch or management server. Go to step 1. If this is
the second time at this step, contact the next level of support. Exit
MAP.
14
Inspect fan module operational states at the SANpilot interface.
a. At the View panel, click the FRU Properties tab. The View panel
(FRU Properties tab) displays.
b. Inspect the Status fields for both power supplies.
Does the Status field display a Failed message for either fan module?
NO YES
↓ A fan module failure is indicated. Go to step 6.
15
Inspect switch CTP operational states at the SANpilot interface.
Inspect the Status fields for the switch CTP.
Does the Status field display a Failed message for the CTP?
NO YES
↓ A CTP card failure is indicated. Replace the switch.
Exit MAP.
Additional analysis is not described in this MAP. Go to MAP 0000:
Start MAP on page 3-6. If this is the second time at this step, contact
the next level of support. Exit MAP.
16
Does a blinking red and yellow diamond (failed FRU indicator) appear
to overlay a combined fan module and power supply graphic at the
Hardware View (Figure 3-10 on page 3-20)?