FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

Diagnostics
3-53
a. Wait approximately five minutes, then attempt to login to the
switch again.
b. At the Netsite field (Netscape Navigator) or Address field
(Internet Explorer), type http://xxx.xxx.xxx.xxx, where
xxx.xxx.xxx.xxx is the IP address of the switch (obtained in
MAP 0000: Start MAP). The Username and Password Required
dialog box appears.
c. Type the user name and password obtained in MAP 0000: Start
MAP and click OK. If the View panel does not display, wait five
minutes and perform this step again.
Does the SANpilot interface appear operational with the View panel
displayed?
NO YES
↓ The switch-to-SANpilot PC connection is restored and
appears operational. Exit MAP.
Failure of the switch Ethernet port is indicated. Replace the switch.
Exit MAP.
7
At the SANavigator or EFCM main window’s physical map or product
list, is a grey square with yellow exclamation mark associated with the
icon representing the switch reporting the problem?
YES NO
↓ The switch-to-server connection is restored and appears
operational. Exit MAP.
The status symbol indicates the management server or customer-
supplied server cannot communicate with the switch because:
• The switch-to-server Ethernet link failed.
• AC power distribution in the switch failed, or AC power was
disconnected.
• The switch CTP card failed.
Continue to the next step.