FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

Diagnostics

3-37

At the management server’s Hardware View (Figure 3-10 on

page 3-20), does a yellow triangle appear at the alert panel and a

blinking red and yellow diamond (failed FRU indicator) appear to

overlay a power supply graphic?

NO YES

↓ A redundant power supply failed. Go to step 8.

At the Hardware View, does a grey square appear at the alert panel, a

No Link status appear at the Sphereon 4500 Status table, and

graphical FRUs appear uninstalled?

YES NO

↓ A green circle appears at the alert panel and the switch

appears operational. Exit MAP.

The grey square indicates the management server or customer-

supplied server cannot communicate with the switch because:

• The switch-to-server Ethernet link failed.

• AC power distribution in the switch failed, or AC power was

disconnected.

• The switch CTP card failed.

Continue to the next step.

Ensure the switch is connected to facility AC power. Inspect the

switch for indications of being powered on, such as:

• At the front bezel, an illuminated PWR LED (green)

or ERR LED (amber).

• Illuminated LEDs adjacent to Fibre Channel ports.

• Audio emanations and airflow from cooling fans.

Does the switch appear powered on?

YES NO

↓ Go to step 13.

Analysis for an Ethernet link or a CTP failure is not described in this

MAP. Go to MAP 0000: Start MAP on page 3-6. If this is the second

time at this step, contact the next level of support. Exit MAP.