FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

2-124

McDATA Sphereon 4500 Fabric Switch Installation and Service Manual

Installation Tasks

• Add member by domain ID and port number - Type the

domain ID (1 through 31) of the switch in the Domain ID field,

type the switch port number (0 through 23) to which a device

is attached, and click the adjacent Add Member button. The

device attached to that port is added to the zone.

• Delete a member - To delete a zone member, click the Delete

button adjacent to the configured zone member (WWN or

domain ID and port number) at the bottom of the page. A

confirmation dialog box displays. Click OK to delete the zone

member.

7. Changes to a zone, zoning configuration, or zone member are not

saved and activated on the switch until saved as part of a zone

set. Go to Configure Zone Sets (SANpilot Interface) below to perform

this function.

Configure Zone Sets

(SANpilot Interface)

To configure zone sets at the SANpilot interface:

1. At the Configure panel and Zoning page, click the Zone Set tab. The

Zoning page displays with the Zone Set tab selected (Figure 2-112).

Figure 2-112 Configure Panel (Zoning Page with Zone Set Tab)