FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

2
2-122
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Installation Tasks
Figure 2-110 Configure Panel (Zoning Page with Zones Tab)
3. Type the zone name and click Add New Zone. After the name is
validated, the new zone name (Zone-1) and an associated Delete
button appear at the bottom of the page. Note the following:
• Save and activate the zone - Changes to a zone or zoning
configuration are not saved and activated on the switch until
saved as part of a zone set. Go to Configure Zone Sets (SANpilot
Interface) on page 2-124 to perform this function.
• Delete all zones - To delete all configured zones and zone
members, click Delete All Zones. A confirmation dialog box
displays. Click OK to delete all zones.
• Delete a single zone - To delete a single zone and its zone
members, click the Delete button adjacent to the zone name. A
confirmation dialog box displays. Click OK to delete the zone.
• Display more zones - If a zone set contains more than 64
zones, the Display More Zones link activates to display
subsequent pages. In addition, the Display Previous Zones link
activates on subsequent displayed pages.