FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

2-120

McDATA Sphereon 4500 Fabric Switch Installation and Service Manual

Installation Tasks

g. Type the SAN management application default user ID and

password and select a server or IP address from the Network

Address drop-down list.

NOTE: The default SAN management application user ID is

Administrator and the default password is password. The user

name and password are case-sensitive.

h. Click Login. The application opens and the SANavigator or

EFCM main window appears (Figure 2-68 on page 2-73).

7. Remove the base restore CD from the CD-RW drive and store the

CD in a safe location. Insert a blank rewritable CD into the

CD-RW drive and format the CD. Refer to step 1 for formatting

instructions.

8. Go to Task 21: Cable Fibre Channel Ports below.

Task 21: Cable Fibre Channel Ports

Perform this task to connect devices to the switch. To cable Fibre

Channel ports:

1. Route fiber-optic jumper cables from customer-specified Fibre

Channel devices, FC-AL devices, or fabric switches to ports at the

front of the switch.

2. Connect device cables to SFP optical port transceivers. Start

with port 0 (far right) and continue sequentially to the left

through port 23.

3. Perform one of the following:

• If the switch is installed on a table or desk top, bundle and

secure the Fibre Channel cables as directed by the customer.

• If the switch is installed in a customer-supplied equipment

rack, bundle Fibre Channel cables from the switch and other

equipment (groups of 16 maximum), and secure them as

directed by the customer.

• If the switch is installed in a McDATA Fabricenter equipment

cabinet, bundle Fibre Channel cables from the switch and

other equipment (groups of 16 maximum), and secure them in

the cable management area at the front-left side of the cabinet.