FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

Installation Tasks

2-115

Installation Tasks

2. At the SANavigator or EFCM main window, select the Event

Notification and Call Home options from the Monitor menu. The

Call Home Event Notification Setup dialog box displays

(Figure 2-103).

Figure 2-103 Call Home Event Notification Setup Dialog Box

3. Click the Enable Call Home Event Notification check box. A check

mark appears in the check box to indicate call-home event

notification is enabled.

NOTE: The enable function must also be activated for each switch

through the Sphereon 4500 Element Manager application. Call-home

event notification can be active for some switches and inactive for others.

4. Click Send Test. A call-home test message is sent.

5. Click OK to close the dialog box.

6. Maximize the Hardware View (Element Manager application).

7. At the Hardware View, select Enable Call Home Notification from the

Maintenance menu. A check mark appears in the check box to

indicate call-home event notification for the switch is enabled,

and the menu closes.

Task 20: Back Up Configuration Data

For the Sanavigator 4.0 application, critical configuration data is

stored on the management server hard drive in the following

directories:

• C:\Program Files\SANavigator4.0\CallHome

• C:\Program Files\SANavigator4.0\Client

• C:\Program Files\SANavigator4.0\Server.