FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

2-114

McDATA Sphereon 4500 Fabric Switch Installation and Service Manual

Installation Tasks

Configure and

Enable Ethernet

Events

Perform this procedure to configure and enable Ethernet events. An

Ethernet event is recorded (after a user-specified time interval) when

the switch-to-management server communication link drops. To

configure and enable Ethernet events:

1. Minimize the Hardware View (Element Manager application) and

return to the SAN management application.

2. At the SANavigator or EFCM main window, select the Ethernet

Event option from the Monitor menu. The Configure Ethernet

Events dialog box displays (Figure 2-102).

Figure 2-102 Configure Ethernet Events Dialog Box

3. Click the Enable Ethernet Events check box. A check mark appears

in the check box to indicate Ethernet events are enabled.

4. At the Ethernet Timeout field, type a value between 10 through 120

minutes.

5. Click OK to close the dialog box.

Configure, Enable,

and Test Call-Home

Event Notification

Telephone numbers and other information for the call-home feature

are configured through the Windows 2000 dial-up networking

application. Refer to Task 11: Configure the Call-Home Feature (Optional)

for configuration instructions. To configure, enable, and test call-

home event notification:

NOTE: The call-home feature may not be available if the EFC Management

applications (EFCM Lite) are installed on a customer-supplied platform.

1. Minimize the Hardware View (Element Manager application) and

return to the SAN management application.