FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

2
2-112
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Installation Tasks
Enable SANpilot
Interface and Telnet
Access
Perform this procedure to enable SANpilot interface and Telnet
access through the maintenance port at the rear of the switch. To
enable these functions:
1. To enable the SANpilot interface at the Hardware View, select
Enable Web Server from the Configure menu. A check mark appears
in the box when the interface is enabled, and the menu closes.
2. To enable Telnet access at the Hardware View, select Enable Telnet
from the Configure menu. A check mark appears in the box when
access is enabled, and the menu closes.
Configure, Enable,
and Test E-mail
Notification
Perform this procedure to configure, enable, and test e-mail and
simple mail transfer protocol (SMTP) addresses to receive notification
of switch (and other product) events. Configure and test procedures
are performed at the SAN management application. E-mail
notification is enabled for each switch at the Element Manager
application. To configure, enable, and test e-mail addresses:
1. Minimize the Hardware View (Element Manager application) and
return to the SAN management application.
2. At the SANavigator or EFCM main window, select the Event
Notification and Email options from the Monitor menu. The Email
Event Notification Setup dialog box displays (Figure 2-101).
Figure 2-101 Email Event Notification Setup Dialog Box
3. To enable e-mail transmission to configured addresses, click the
Enable Email Event Notification check box. A check mark appears
in the box when transmission is enabled.