FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

Installation Tasks

2-103

Installation Tasks

2. Select from the drop-down list in the Speed column to configure

the port transmission rate. Available selections are:

• Auto-negotiate between 1.0625 and 2.125 Gbps

operation (Negotiate). This is the default selection.

• 1.0625 Gbps operation (1 Gig).

• 2.125 Gbps operation(2 Gig).

f. Click the check box in the Port Binding column to enable or

disable port binding (default is disabled). A check mark in the

box indicates port binding is enabled and the port can connect

only to a device with a WWN listed in the Bound WWN

column.

g. If port binding is enabled, type the WWN or nickname of the

device attached to the port in the Bound WWN column.

• If the check box in the Port Binding column is checked and a

WWN or nickname appears in the Bound WWN field, only

the specified device can attach to the port.

• If the check box in the Port Binding column is checked but

no WWN or nickname appears in the Bound WWN field, no

device can connect to the port.

• If the check box in the Port Binding column is not checked,

any device can connect to the port.

3. Click Activate to save the information and close the Configure Ports

dialog box.

Configure SNMP

Trap Message

Recipients

Perform this procedure to configure community names, write

authorizations, and network addresses and for up to 12 SNMP trap

message recipients. A trap recipient is a management workstation

that receives notification (through SNMP) if a switch event occurs. To

configure SNMP trap recipients:

1. At the Hardware View, select SNMP Agent from the Configure

menu. The Configure SNMP dialog box displays (Figure 2-94 on

page 2-104).